Waste & Water Tanks

Note: THE FOLLOWING TANKS ARE NOT RATED FOR FUEL

Our tanks are heavy walled, one-piece roto-molded polyethylene tanks.

Our smallest tanks have a minimum wall thickness of 3/8ths of an inch. Larger tanks have increasingly thicker walls. Our tanks are the best quality tanks that we’ve come across, and we’ve seen them all!

Each tank is built to order and takes about two weeks to be shipped to you.

We can put the fittings where you need them!

When you order a tank we ask that you fax us a drawing of the tank with the fitting locations marked on the drawing. When you make a drawing for us, please take care to make your drawing accurate and easy to read, using clear penmanship. (We’re not so good at reading hieroglyphics). Include all the dimensions of the tank and clearly mark the fitting locations. NOTE: You can explode the thumbnail and print a picture of the tank to draw the fittings on.

Do not assume the tank has an obvious top, bottom, or side, which is only determined by the fitting locations. The tanks can be installed in any orientation

Please include a daytime phone number so we can reach you if we have any questions. Check out the pictures of the different fittings that we can install. The tanks listed on the page can be configured for waste or water but NOT for fuel.

We install dip tubes in our waste tanks. Dip tubes are pipes that extend down into the tank from the top of the tank to the bottom. We can also install them in the top of a side of a tank. Check out the pictures. We can supply you with a variety of different angled elbows and adapters to make your hose connections easy.

We have tried to make it as easy as possible to select the best tank for your needs. We have over 350 tanks. We have organized the tanks by shape. The rectangular tanks are easy to search. Click on GO! and a search engine pops up, plug in your three dimensions and see what happens.

The shaped tanks are somewhat more time consuming to search through. Click on the shape category, and scroll through the selections. You have to explode the thumb nails one at a time to view the tanks properly. If you have good measurements you can often find the perfect fit for the space you have. We can give you some suggestions to help you find the tank of your dreams, but for obvious reasons we cannot select the tank for you without seeing the boat.

Tank Search

Search By Gallons

Search By Product Number

OLT-

THE FOLLOWING IS OUR TANK SELECTION GUIDE:
Rectangular Tanks are, as you may expect, rectangles. We have hundreds of Rectangular tanks, so we are providing you a great way to search for the size tank you are looking for.
Bow Tanks are designed to fit in the bow area of your yacht. Many boats have unused space under a V-berth where a bow tank makes the best use of the available space.
Keel tanks are shaped to fit in the bilge or keel area on centerline.
Side tanks are shaped to fit along the side of the yacht. Many people find a spot under a settee which is perfect for a side tank. When selecting a side tank, be sure to check for "handedness", some fit better port or starboard
Funky tanks are oddball shapes with funny notches and cutouts. While hard to categorize, you may find one that's perfect